Pro-Tech 8 Titan

Materials & Layering

The palm side outermost layer is water repellent suede goat skin tanned and designed to resist cracking, peeling, and stiffening while also providing a sure grip when wet.
The ring and middle finger's suede are cut and sewn independently for enhanced dexterity.
Underneath the suede there is a full layer of blended 64% Kevlar® / 36% Nomex® and two partial layers of 100% Nomex® that run from mid-palm to the cuff edge.
The inner liner on the palm side is another full layer of 100% Nomex®.
The back side of the outer layer is mostly water repellent goat skin leather which covers the finger tip area, a 1" wide suede welt along the finger crotch and from the knuckle guard to the cuff edge.
Underneath the leather portions on the glove back side are a full layer of 100% Kevlar® and another full layer of 100% Nomex®.
The inner liner on the back side is another layer of 100% Nomex®.
The knuckle guard portion has an outer layer of 100% Kevlar®, one layer of 100% Nomex® and two layers of silicon carbide both fused with 100% Kevlar®, another layer of 100% Kevlar® and another layer of 100% Nomex® which represents the inner liner. This unique layered system provides repetitive thermal protection at the vulnerable knuckle compression point.
The finger side walls are comprised of an outer layer 64%Kevlar® / 36% Nomex®, and two underneath layers of 100% Nomex®.
The gloves inner layers are fully lined with a double layer of breathable polymer moisture barrier completely sealed in the finger and sidewall area to prevent liquid penetration.
The glove inner cuff construction is supported by 1 1/2 inch wide leather welting. Identical welting is used additionally within the inner layers of the cuff construction, all to prevent moisture wicking and to enhance support and durability.
100% Kevlar® high burst thread and 100% Kevlar® edge piping is used throughout the gloves.